Skip to content

NanoSPR USB driver install instructions

Untitled Document

1. Download USB driver for Windows XP/Vista/7/8:

2.Click on the link to start installation of USB driver for NanoSPR 6XX/8XX:

start usb driver setup

3. The driver installation wizard will start, click "Next":

driver installation wizard


4. Click "I accept the terms of the license agreement":

license agreement

5. Select the folder where to install the driver (you can leave the default location):

select installation folder

6. Click "Install" to begin installation:

begin installation

7. Installation is in progress:

installation progress


8. Click "Finish" to finalize the installation and begin CP210x driver installation:

installation wizard complete


9. Click "Install" to begin CP210x driver installation:

driver install

10.Driver install progress (may take a few minutes):

driver install progress

11. Driver was successfully installed, click "OK" to close the window:

driver setup complete

12. Restart the Windows (to make sure device driver will initialize properly).

13. Now plug in NanoSPR Device USB cable to any available computer USB port, plugin power supply and turn the power switch on the NanoSPR device.
Windows will detect the "Silicon Laboratories CP210X" device and will install it in the system.

The device driver is installed at this point.

Feedback and Knowledge Base